Cheaper over time
A scrub and recoat costs a fraction of a full strip and finish. Done on schedule, it pushes the expensive job out by years.
Floor and surface care · periodic
Floor care,
scheduled so it never slips.
Nightly vacuuming and mopping keep floors clean. They don't bring back traffic lanes on carpet, or the finish on VCT that's been walked down to bare tile. That takes periodic work, and periodic work is the first thing that slips when nobody schedules it.
We put floor care on the scope with a frequency: carpet extraction quarterly, a scrub and recoat twice a year, a full strip and finish when it's due. It shows up on the calendar, gets done, and gets reported.
What we do
Carpet
- Hot water extraction
- Traffic lane and spot treatment
- Low-moisture encapsulation between extractions
- Entry and walk-off mats
- Upholstery cleaning
Hard floors
- Scrub and recoat (VCT, LVT, sealed concrete)
- Full strip and refinish
- Burnishing high-traffic areas
- Tile and grout deep cleaning
- Sealed concrete maintenance
Surfaces
- Interior and partition glass
- High dusting: vents, ledges, fixtures
- Baseboards and kick plates
- Restroom tile and grout scrub
- Stairwells
Why scheduled beats as-needed
Carpet lasts longer
Grit in carpet fibers wears them like sandpaper. Regular extraction removes it before traffic lanes become permanent.
Planned around you
Floor work happens on nights or weekends when the area can be closed and dry by morning. The date is on the calendar weeks ahead.
One vendor
Your nightly crew and your floor work under one scope and one invoice, so nobody argues about whose job the floors are.
For buildings without nightly service
Floor care is available as a standalone service too: a one-time carpet extraction before a move-in, a strip and finish for a retail floor, or a quarterly program for a building that does its own daily cleaning. Quoted after a walkthrough.
Buildings we clean
Where we work
Questions about floor care
How often should commercial carpet be cleaned?
Most offices do hot water extraction two to four times a year, with traffic lanes and entries more often. Heavy-traffic lobbies may need monthly attention.
What's the difference between a scrub and recoat and a strip and wax?
A scrub and recoat cleans the top layer of floor finish and adds new coats. A strip removes all the old finish down to the tile before refinishing. Regular recoats delay the much bigger strip job.
How long before we can walk on the floor?
Extracted carpet is usually dry in a few hours with air movers. Refinished hard floors need several hours to cure, which is why we schedule them overnight or on weekends.